1WICD-MANAGER-SETTINGS.CONF(5) File Formats ManualWICD-MANAGER-SETTINGS.CONF(5)
2
3
4

NAME

6       wicd-manager-settings.conf  -  contains  settings  that  control Wicd's
7       behavior
8
9

DESCRIPTION

11       This file contains general configuration information for Wicd.
12       This file is located at /etc/wicd/manager-settings.conf
13
14

SETTINGS

16       link_detect_tool = <0|1|2>
17              0 = autodetect
18              1 = ethtool
19              2 = mii-tool
20
21       flush_tool = <0|1|2>
22              0 = autodetect
23              1 = ip
24              2 = route
25
26       backend = <ioctl|external>
27              Default is ioctl backend.
28
29       signal_display_type = <0|1>
30              0 = Show signal strength as a percentage
31              1 = Show signal strength in dBm
32
33       dhcp_client = <0|1|2|3>
34              0 = autodetect
35              1 = dhclient
36              2 = dhcpcd
37              3 = pump
38
39       sudo_app = <0|1|2|3>
40              0 = autodetect
41              1 = gksu
42              2 = kdesu
43              3 = ktsuss
44
45       wired_interface = <interface_name>
46
47       always_show_wired_interface = <True|False>
48
49       wired_connect_mode = <0|1>
50              0 = connect to wired interface automatically
51              1 = do not connect to wired interface automatically
52
53       prefer_wired = <True|False>
54              True = Switch to wired interface if a link is detected, even  if
55              already connected to wireless
56              False = Do not switch to wired interface automatically
57
58       wireless_interface = <name_of_wireless_interface>
59
60       wpa_driver    =    <wext|madwifi|ndiswrapper|hostap|hermes|atmel|broad‐
61       com|ipw|ralinklegacy|none>
62              The default (and best supported) is wext.  It should work  prop‐
63              erly  in  most cases.  The none special value makes WICD pass no
64              -D parameter to wpa_supplicant, which might be  useful  in  some
65              cases.
66
67       auto_reconnect = <True|False>
68              This  settings determines whether Wicd will attempt to reconnect
69              on connection loss.
70
71       use_global_dns = <True|False>
72              If set to "True" and values are specified in the global DNS set‐
73              tings below, this will cause Wicd to use these DNS settings.
74
75       global_dns_dom = <plaintext_domain_name>
76              This  specifies  the  default  search  domain  to be used by the
77              resolver.
78
79       global_dns_1 = <ip_address>
80
81       global_dns_2 = <ip_address>
82
83       global_dns_3 = <ip_address>
84
85       debug_mode = <integer_value>
86              0 = disabled
87              1 = enabled
88
89
90

SEE ALSO

92       wicd(8),  wicd-curses(8),  wicd-wired-settings.conf(5),  wicd-wireless-
93       settings.conf(5).
94
95
96
97
98                                  wicd-1.7.4     WICD-MANAGER-SETTINGS.CONF(5)
Impressum