1SHOREWALL6-TCINTERF(5)          [FIXME: manual]         SHOREWALL6-TCINTERF(5)
2
3
4

NAME

6       tcinterfaces - Shorewall6 file
7

SYNOPSIS

9       /etc/shorewall6/tcinterfaces
10

DESCRIPTION

12       This file lists the interfaces that are subject to simple traffic
13       shaping. Simple traffic shaping is enabled by setting TC_ENABLED=Simple
14       in shorewall6.conf[1](5).
15
16       A note on the bandwidth definition used in this file:
17
18       ·   don't use a space between the integer value and the unit: 30kbit is
19           valid while 30 kbit is not.
20
21       ·   you can use one of the following units:
22
23           kbps
24               Kilobytes per second.
25
26           mbps
27               Megabytes per second.
28
29           kbit
30               Kilobits per second.
31
32           mbit
33               Megabits per second.
34
35           bps or number
36               Bytes per second.
37
38           k or kb
39               Kilo bytes.
40
41           m or mb
42               Megabytes.
43
44       ·   Only whole integers are allowed.
45
46       The columns in the file are as follows.
47
48       INTERFACE
49           The logical name of an interface. If you run both IPv4 and IPv6
50           Shorewall firewalls, a given interface should only be listed in one
51           of the two configurations.
52
53       TYPE - [external|internal]
54           Optional. If given specifies whether the interface is external
55           (facing toward the Internet) or internal (facing toward a local
56           network) and enables SFQ flow classification.
57
58               Note
59               Simple traffic shaping is only useful on interfaces where
60               queuing occurs. As a consequence, internal interfaces seldom
61               benefit from simple traffic shaping. VPN interfaces are an
62               exception because the encapsulated packets are later
63               transferred over a slower external link.
64
65       IN-BANDWIDTH - [rate[:burst]]
66           Optional. If specified, enables ingress policing on the interface.
67           If incoming traffic exceeds the given rate, received packets are
68           dropped randomly. With some DSL and Cable links, large queues can
69           build up in the ISP's gateway router. While this insures maximum
70           throughput, it kills interactive response time. By setting
71           IN-BANDWIDTH, you can eliminate these queues.
72
73           To pick an appropriate setting, we recommend that you start by
74           setting it significantly below your measured download bandwidth
75           (20% or so). While downloading, measure the ping response time from
76           the firewall to the upstream router as you gradually increase the
77           setting.The optimal setting is at the point beyond which the ping
78           time increases sharply as you increase the setting.
79
80           The burst option was added in Shorewall 4.4.13. If not supplied,
81           10kb is assumed. A larger burst size can help make the rate
82           estimate more accurate on fast lines. The default burst often make
83           the enforced rate mush less that the specified rate.
84
85       OUT-BANDWIDTH - [rate[:[burst][:[latency][:[peek][:[minburst]]]]]]
86           Added in Shorewall 4.4.13. The terms are defined in tc-tbf(8).
87
88           Shorewall provides defaults as follows:
89               burst - 10kb
90               latency - 200ms
91           The remaining options are defaulted by tc(8).
92

FILES

94       /etc/shorewall6/tcinterfaces.
95

SEE ALSO

97       http://ace-host.stuart.id.au/russell/files/tc/doc/sch_tbf.txt
98
99       shorewall6(8), shorewall6-accounting(5), shorewall6-actions(5),
100       shorewall6-blacklist(5), shorewall6-hosts(5), shorewall6-maclist(5),
101       shorewall6-params(5), shorewall6-policy(5), shorewall6-providers(5),
102       shorewall6-route_rules(5), shorewall6-routestopped(5),
103       shorewall6-rules(5), shorewall6.conf(5), shorewall6-secmarks(5),
104       shorewall6-tcpri, shorewall6-tos(5), shorewall6-tunnels(5),
105       shorewall6-zones(5)
106

NOTES

108        1. shorewall6.conf
109           http://www.shorewall.net/manpages6/shorewall6.conf.html
110
111
112
113[FIXME: source]                   09/16/2011            SHOREWALL6-TCINTERF(5)
Impressum