1mcat(1)                     General Commands Manual                    mcat(1)
2
3
4

Name

6       mcat - dump raw disk image
7
8
9

Note of warning

11       This  manpage  has  been  automatically generated from mtools's texinfo
12       documentation, and may not be entirely accurate or complete.   See  the
13       end of this man page for details.
14

Description

16       The  mcat  command  is used to copy an entire disk image from or to the
17       floppy device. It uses the following syntax:
18
19       mcat [-w] drive:
20
21       Mcat performs the same task as the Unix cat  command.  It  is  included
22       into  the mtools package, since cat cannot access remote floppy devices
23       offered by the mtools floppy daemon.  Now it is possible to create boot
24       floppies remotely.
25
26       The default operation is reading. The output is written to stdout.
27
28       If  the  -w option is specified, mcat reads a disk-image from stdin and
29       writes it to the given device.  Use this carefully! Because of the low-
30       level  nature of this command, it will happily destroy any data written
31       before on the disk without warning!
32

See Also

34       Mtools' texinfo doc
35

Viewing the texi doc

37       This manpage has been automatically  generated  from  mtools's  texinfo
38       documentation.  However,  this  process is only approximative, and some
39       items, such as crossreferences, footnotes and indices are lost in  this
40       translation process.  Indeed, these items have no appropriate represen‐
41       tation in the manpage format.  Moreover, not all information  has  been
42       translated into the manpage version.  Thus I strongly advise you to use
43       the original texinfo doc.  See the end of this manpage for instructions
44       how to view the texinfo doc.
45
46       *      To  generate a printable copy from the texinfo doc, run the fol‐
47              lowing commands:
48
49                     ./configure; make dvi; dvips mtools.dvi
50
51
52
53       *      To generate a html copy,  run:
54
55                     ./configure; make html
56
57       A premade html can be found at `http://www.gnu.org/software/mtools/man
58       ual/mtools.html'
59
60       *      To  generate  an  info  copy (browsable using emacs' info mode),
61              run:
62
63                     ./configure; make info
64
65
66
67       The texinfo doc looks most pretty when printed or as html.  Indeed,  in
68       the  info  version  certain  examples  are difficult to read due to the
69       quoting conventions used in info.
70
71mtools-4.0.36                       21Nov21                            mcat(1)
Impressum