1DMASCC_CFG(1)              Linux Programmer's Manual             DMASCC_CFG(1)
2
3
4

NAME

6       dmascc_cfg - Configure dmascc devices
7

SYNOPSIS

9       dmascc <interface> [<options>]
10

DESCRIPTION

12       dmascc_cfg  is  used  to configure dmascc devices such as PI2 and Pack‐
13       eTwin cards.  The --show option can be used  by  any  user,  all  other
14       options must be used by root.
15

OPTIONS

17       --speed frequency
18                 Set frequency of baud rate generator to frequency. A value of
19                 0 disables the baud rate generator and the digital  PLL.  Use
20                 the --show option to check whether the frequency you selected
21                 could be approximated with sufficient accuracy.
22
23       --nrzi [0|1]
24                 0 selects NRZ mode, 1 selects NRZI mode.
25
26       --clocks integer
27                 Set the clock mode. You may OR together three choices  (other
28                 values are not supported and may cause strange results).
29
30       TX clock pin:
31
32              0x00 input
33              0x05 output TX clock *
34              0x06 output baud rate generator *
35              0x07 output digital PLL *
36
37       TX clock source:
38
39              0x00 RX clock pin
40              0x08 TX clock pin #
41              0x10 baud rate generator
42              0x18 digital PLL +
43
44       RX clock source:
45
46              0x00 RX clock pin
47              0x20 TX clock pin
48              0x40 baud rate generator
49              0x60 digital PLL +
50
51       * Not allowed on PI2 Port A if J3 is installed.
52
53       # TX clock pin must be configured as input.
54
55       + Speed must be equal to 32 times the baud rate.
56
57       --txdelay milliseconds
58                 Set transmit delay to milliseconds. Maximum is 2500 ms.
59
60       --txtime seconds
61                 Set maximum time the transmitter may be active to seconds.
62
63       --sqdelay milliseconds
64                 Set  the squelch delay to milliseconds. Maximum delay is 2500
65                 ms.
66
67       --slottime milliseconds
68                 Set the slot time to milliseconds. Maximum slottime  is  2500
69                 ms.
70
71       --waittime milliseconds
72                 Set  the  minimum time between the transmitter turning off to
73                 when it turns on to milliseconds. Maximum wait time  is  2500
74                 ms.
75
76       --persist f
77                 Set the persistance parameter to f. Must be between 0 and 255
78                 (inclusive).
79
80       --dma channel
81                 Set the DMA channel to channel. Can be 1 or 3.  Setting to  0
82                 disables DMA.
83

BUGS

85       dmascc_cfg  does  not  check the parameters for validity. The driver or
86       kernel may crash if you specify invalid values.
87

AUTHORS

89       Klaus Kudielka
90       This manual page written by Craig Small <csmall@small.dropbear.id.au>
91
92
93
94Linux                            30 June 1999                    DMASCC_CFG(1)
Impressum