oneac(8) - f36

1ONEAC(8)                          NUT Manual                          ONEAC(8)
2
3
4

NAME

6       oneac - Driver for Oneac UPS equipment
7

NOTE

9       This man page only documents the hardware-specific features of the
10       oneac driver. For information about the core driver, see nutupsdrv(8).
11

SUPPORTED HARDWARE

13       This driver supports various Oneac UPS families:
14
15       ·   EG (late 80s, early 90s, plug-in serial interface card)
16
17       ·   ON (early and mid-90s, plug-in serial interface card)
18
19       ·   OZ (mid-90s on, DB-25 std., interface slot)
20
21       ·   OB (early 2000’s on, big cabinet, DB-25 std., interface slot)
22
23       If your UPS is equipped with the Basic Interface card, use the
24       genericups(8) driver.
25

EXTRA ARGUMENTS

27       This driver supports the following optional settings in the ups.conf(5)
28       file:
29
30       testtime=num
31           Change battery test time from the 2 minute default.
32
33       offdelay=num
34           Change shutdown delay time from 0 second default.
35

INSTANT COMMANDS

37       This driver supports the following Instant Commands. (See upscmd(8))
38
39   All UPS units
40       shutdown.return
41           Turn off the load possibly after a delay and return when power is
42           back.
43
44       shutdown.stop
45           Stop a shutdown in progress.
46
47       shutdown.reboot
48           Shut down the load briefly while rebooting the UPS.
49
50       test.failure.start
51           Starts a 15 second long simulation of an input power failure.
52
53       test.battery.start.quick
54           Start a "quick" battery test. The default time is 2 minutes. This
55           time can be set in the ups.conf file. See testime above.
56
57       test.battery.stop
58           Stops a battery test that is in progress.
59
60   All ON UPS units
61       reset.input.minmax
62           Reset the minimum and maximum input line voltage values seen since
63           the last reset or power on.
64
65   Newer ON UPS units
66       test.panel.start
67           Start testing the UPS panel.
68
69       test.battery.start.deep
70           Start a "deep" battery test. This test runs the UPS until the low
71           battery point and then returns to the AC line.
72
73       reset.input.minmax
74           Reset the minimum and maximum input line voltage values seen since
75           the last reset or power on.
76
77       beeper.enable
78           Enable UPS beeper/buzzer.
79
80       beeper.disable
81           Disable UPS beeper/buzzer.
82
83       beeper.mute
84           Mutes the UPS beeper/buzzer for the current alarm condition(s).
85

WRITABLE VARIABLES

87       See upsrw(8) to see what variables are writable for the UPS.
88
89           Note
90           If your UPS supports writing battery.runtime.low, the new set value
91           is to be entered in minutes (up to 99) but the reported value is
92           reported in seconds (set value * 60).
93
94           Note
95           If your UPS supports input.transfer.low and input.transfer.high,
96           those values are used to create an allowable output range. The UPS
97           will do what it can to keep the output voltage value within the
98           defined range (for example: tap change or switch to inverter).
99

AUTHOR

101       Bill Elliot <bill@wreassoc.com>, Eric Lawson <elawson@inficad.com>
102