1UHD_RX_NOGUI(1)                  User Commands                 UHD_RX_NOGUI(1)
2
3
4

NAME

6       uhd_rx_nogui - GNU Radio receiver
7

SYNOPSIS

9       uhd_rx_nogui.py [options]
10

DESCRIPTION

12       Command line GNU Radio receiver that takes signal from a UHD peripheral
13       receiver and sends demodulated audio to the sound device.
14

OPTIONS

16       -h, --help
17              show this help message and exit
18
19       -a ARGS, --args=ARGS
20              UHD device address args , [default=]
21
22       --spec=SPEC
23              Subdevice of UHD device where appropriate
24
25       -A ANTENNA, --antenna=ANTENNA
26              select Rx Antenna where appropriate [default=none]
27
28       -f Hz, --frequency=Hz
29              set receive frequency to Hz [default=none]
30
31       -c Hz, --calibration=Hz
32              set frequency offset to Hz [default=0.0]
33
34       -g dB, --gain=dB
35              set RF gain [default is midpoint]
36
37       -m TYPE, --modulation=TYPE
38              set modulation type (AM,FM) [default=none]
39
40       -o RATE, --output-rate=RATE
41              set audio output rate to RATE [default=32000]
42
43       -r dB, --rf-squelch=dB
44              set RF squelch to dB [default=-50.0]
45
46       -p FREQ, --ctcss=FREQ
47              set CTCSS squelch to FREQ [default=none]
48
49       -O AUDIO_OUTPUT, --audio-output=AUDIO_OUTPUT
50              pcm device name.  E.g., hw:0,0 or surround51 or /dev/dsp
51

SEE ALSO

53       uhd_fft(1) uhd_rx_cfile(1) uhd_siggen(1) uhd_siggen_gui(1)
54
55
56
57uhd_rx_nogui 3.10.3.0             2022-07-30                   UHD_RX_NOGUI(1)