1dtest(1) USER COMMANDS dtest(1)
2
3
4
6 dtest - simple uDAPL send/receive and RDMA test
7
8
10 dtest [-P provider] [-b buf size] [-B burst count][-v] [-c] [-p] [-d]
11 [-s]
12
13 dtest [-P provider] [-b buf size] [-B burst count][-v] [-c] [-p] [-d]
14 [-h HOSTNAME]
15
16
18 dtest is a simple test used to exercise and verify the uDAPL inter‐
19 faces. At least two instantiations of the test must be run. One acts
20 as the server and the other the client. The server side of the test,
21 once invoked listens for connection requests, until timing out or
22 killed. Upon receipt of a cd connection request, the connection is
23 established, the server and client sides exchange information necessary
24 to perform RDMA writes and reads.
25
26
28 -P=PROVIDER
29 use PROVIDER to specify uDAPL interface using /etc/dat.conf
30 (default OpenIB-cma)
31
32 -b=BUFFER_SIZE
33 use buffer size BUFFER_SIZE for RDMA(default 64)
34
35 -B=BURST_COUNT
36 use busrt count BURST_COUNT for interations (default 10)
37
38 -v, verbose output(default off)
39
40 -c, use consumer notification events (default off)
41
42 -p, use polling (default wait for event)
43
44 -d, delay in seconds before close (default off)
45
46 -s, run as server (default - run as server)
47
48 -h=HOSTNAME
49 use HOSTNAME to specify server hostname or IP address (default -
50 none)
51
52
54 dtest -P OpenIB-cma -v -s
55
56 Starts a server process with debug verbosity using provider OpenIB-cma.
57
58 dtest -P OpenIB-cma -h server1-ib0
59
60 Starts a client process, using OpenIB-cma provider to connect to hostname server1-ib0.
61
62
63
65 dapltest(1)
66
67
69 Arlin Davis
70 <ardavis@ichips.intel.com>
71
72
74uDAPL 1.2 February 23, 2007 dtest(1)