1git-annex-registerurl(1)    General Commands Manual   git-annex-registerurl(1)
2
3
4

NAME

6       git-annex-registerurl - registers an url for a key
7

SYNOPSIS

9       git annex registerurl [key url]
10

DESCRIPTION

12       This  plumbing-level  command  can be used to register urls where a key
13       can be downloaded from.
14
15       No verification is performed of the url's contents.
16
17       Normally the key is a git-annex formatted key. However, to make it eas‐
18       ier  to use this to add urls, if the key cannot be parsed as a key, and
19       is a valid url, an URL key is constructed from the url.
20

OPTIONS

22       --batch
23
24              In batch input mode, lines are read from stdin,  and  each  line
25              should contain a key and url, separated by a single space.
26
27              For  backwards  compatability with old git-annex before this op‐
28              tion was added, when no key and url pair are  specified  on  the
29              command  line,  batch  input is used, the same as if the --batch
30              option were specified. It is however recommended to use --batch.
31
32       -z     When in batch mode, the input is delimited by nulls  instead  of
33              the usual newlines.
34
35              (Note  that  for  this to be used, you have to explicitly enable
36              batch mode with --batch)
37
38       Also the git-annex-common-options(1) can be used.
39

SEE ALSO

41       git-annex(1)
42
43       git-annex-addurl(1)
44
45       git-annex-unregisterurl(1)
46

AUTHOR

48       Joey Hess <id@joeyh.name>
49
50                                                      git-annex-registerurl(1)