1DLT_GATEWAY.CONF(5) DLT_GATEWAY.CONF(5)
2
3
4
6 dlt_gateway.conf - DLT configuration file for gateway
7
9 The configuration file dlt_gateway.conf allows to configure the differ‐
10 ent runtime behaviour of gateway in Multinode feature.
11
12 The configuration file is written in an INI file format and contains
13 information about different connected passive nodes.
14
15 If Multinode feature is enabled, dlt-daemon loads by default the con‐
16 figuration file /etc/dlt_gateway.conf.
17
18 An alternative configuration file can be loaded by changing GatewayCon‐
19 figFile in dlt.conf(5).
20
22 Interval
23 Time interval for reconnection to passive Node in second.
24
25 Default: 1
26
28 Each passive node’s connection parameters are specified in a unique
29 numbered separate section
30
31 ([PassiveNode{1,2, ...N}]).
32
33 Example: [PassiveNode1]
34
35 IPaddress
36 Because TCP is the only supported communication channel,
37
38 the IPaddress and Port of the Passive DLT Daemon has to be specified.
39
40 IP Address of passive node. Mandatory
41
42 Port
43 TCP port. Default 3490 is used if no port is specified.
44
45 Default: 3490
46
47 EcuID
48 ECU identifier of passive node. Mandatory.
49
50 Connect
51 With the Connect property it is possible to specify when the Gateway
52 DLT Daemon shall connect to the passive node.
53
54 Default: OnStartUp
55
56 The following values are allowed:
57
58 OnStartup The Gateway DLT Daemon tries to connect to the Passive DLT Daemon
59 immediately after the Gateway DLT Daemon is started.
60 OnDemand The Gateway DLT Daemon tries to connect to the Passive DLT Daemon
61 when it receives a connection request.
62
63 Timeout
64 Stop connecting to passive node, if not successful after 10 retries.
65
66 After of retries, the connection to passive Node is marked as DISABLED.
67
68 It means there is no any retry anymore.
69
70 Set to 0 for endless retry.
71
72 Default: 10
73
74 SendControl
75 Send following control messages after connection is established. Op‐
76 tional.
77
78 Default: disabled
79
80 Supported Control messages:
81
82 DLT_SERVICE_ID_GET_LOG_INFO 0x03
83 DLT_SERVICE_ID_GET_DEFAULT_LOG_LEVEL 0x04
84 DLT_SERVICE_ID_GET_SOFTWARE_VERSION 0x13
85
86 SendSerialHeader
87 Send Serial Header with control messages. Value in dlt.conf(5) is used
88 as default if not specified.
89
90 Default: disabled
91
92 SendPeriodicControl
93 Send following control messages periodically.
94
95 Default: disabled
96
97 Format:
98
99 control:interval[in seconds]
100
102 Thanh Bui Nguyen Quoc (thanh.buinguyenquoc (at) vn (dot) bosch (dot)
103 vn)
104
106 Copyright (C) 2020 Advanced Driver Information Technology, Bosch and
107 DENSO. License MPL-2.0: Mozilla Public License version 2.0
108 http://mozilla.org/MPL/2.0/.
109
111 See Github issue: <https://github.com/GENIVI/dlt-daemon/issues>
112
114 dlt.conf(5), dlt-daemon(1)
115
116
117
118 DLT_GATEWAY.CONF(5)